Install your Trichopure Shower Filter in approximately 2 minutes—no tools or professional installation required.

Step 1
Remove the silicone plugs from both ends of the shower filter.

Step 2
Unscrew and remove your existing shower head from the shower arm.

Step 3
Connect the Trichopure Shower Filter to the shower arm and hand-tighten securely.

Step 4
Reattach your shower head to the bottom of the Trichopure Shower Filter and tighten by hand.

Step 5
Turn on the shower and allow water to run briefly. Check all connection points for leaks before use.

Engineered to fit standard shower connections. For fixed, angled, or less accessible shower arms, pair with the Trichopure Swivel Adapter for a seamless fit.

How to Replace Your Trichopure Refill Cartridge

Turn off your shower. Ensure the water is completely off.

Open the housing. Unscrew the filter housing and remove the used cartridge.

Rinse the housing. Rinse the inside with clean water.

Prepare your new refill. Remove all packaging and remove the silicone plugs from both ends of the new cartridge.

Insert the cartridge. Position it in the same orientation as the previous one.

Close and secure. Check that the sealing rings are in place, then hand-tighten the housing securely.

Flush before use. Run water for 30 seconds and check for leaks.